hello,


Looking for some insight just bought a new meteor cylinder kit for an 046 Stihl. Casting was less than perfect but I figured I'd start to clean up marks and uneven spots. After starting to do this I looked inside and noticed the bad casting went all the way through and was plated around. Intake port is overly wide with a sharp corner where port is supposed to be rounded.
Looks like ring ends won't protrude into bad spot but I'm worried it might still hook. Since i started to polish ports sending it back isn't happening. Do I try it or eat the cylinder cost and try another one or different brand since maybe meteor has bad mold for particular saw. Will send pictures when I get out to shop



Please help.
Thanks!


I didn't find the right solution from the Internet.




References:
http://opeforum.com/threads/bad-meteor-cyl...stihl-046.8647/



Product Ad